AEG 7 Serie Mode D'emploi page 17

Getting started
GB
1. Before first use: Boil water in the
kettle and pour it out. Repeat for
2 or 3 times. This will remove any
remaning dust or residues.
(See the following steps on how to
use the kettle).
Wipe the outside of the kettle with a
damp cloth.
4. Close the lid and make sure that it
snaps in correctly. Otherwise, the
auto switch off function will not work
reliably.
Place the kettle on the base.
The LCD display will be illuminated,
(followed by one long beep sound), to
indicate that the appliance is plugged
in. The appliance is now in standby
mode.
2. Place the base unit on a firm and flat
surface. Plug the mains plug into a
wall socket. Redundant cord can be
wound up at the bottom of base unit.
5. Press the Start/Cancel button to
start or stop boiling water.
(One short beep will sound)
Note: Press and hold the Start/Cancel
button longer to enter energy saving
mode (LCD turned off). (One long beep
will sound)
When the boiling process is finished,
two short beep followed by one long
beep sound will sound.
3. Press the Open lid button to open
the lid. Fill the kettle with fresh tap
water to the desired level (Min. 0.5L -
Max.1.7L).
6. The automatic switch off function.
When the water has boiled or the
kettle is moved from the base, it will
switch off automatically. If you wish
to stop the heating process before
the water is boiling, simply press the
Start/Cancel button.
D
GR
NL
F
GB
17