Kerbl 17460 Mode D'emploi page 7

Dehorning
Proceed as follows:
1. Secure the calf's head properly, if necessary with the help of another person.
2. Remove any hair in the area to be treated.
3. F irmly burn out the horn attachment point by holding the burning bulb against it in a circular motion for around 7 seconds.
4. Release the inner section of the burning ring by laying the burning tip on its edge.
5. Place the device in the holder and allow it to air-cool.
6. Apply an antiseptic powder to the horn attachment points in order to avoid suppurating or purulent wounds.
Maintenance
Check all components for signs of damage before every use. Damaged parts should only be repaired by a qualified professional or the
manufacturer. If carrying out any repairs, only use original spare parts.
Changing the burning tip
CAUTION!
Hot burning tip! Danger of fire and injury!
• Allow the burning tip to cool down before changing it.
Proceed as follows:
1. Loosen the clamping screw on the burning tip with an Allen wrench and remove the burning tip.
2. Insert the new burning tip until it stops and then tighten the clamping screw.
Technical data
Article number
Input voltage safety transformer
Power
Max. temperature at the burning ring
Heating time
Diameter of the burning tip
Cable length
Weight
Spare parts
17455 Burning rod with burning tip and plug
17451 Burning tip 18 mm
17452 Burning tip 15 mm
17463 Screw for burning tips 17451 and 17452
17462 Heating cartridge
1710-0 Safety transformer
17181 Merten plug
17183 Socket for safety transformer incl. cover
17184 Fuse 5 x 20 mm; 2.5 A
1711 Device holder
Electronic scrap
Disposing of this device after its service life is the responsibility of the operator.
Please consult the valid national regulations. The device must not be disposed of in household waste. In accordance with the stipulati-
ons of the EU Directive on the Disposal of Electrical and Electronic Devices, the device can be disposed of free of charge at the local
waste collection or recycling centre. Alternatively, it can be returned to retailers who offer a collection service. The proper disposal
helps to ensure environmental protection and prevents any adverse effects on human health and the environment.
Declaration of conformity
Albert KERBL GmbH hereby declares that the product / device described in these instructions complies with the fundamental requirements and
other relevant stipulations of Directive 2004/108/EC and 2006/95/EC. The CE mark confirms compliance with the Directives of the European Uni-
on. The declaration of conformity can be viewed by visiting http://www.kerbl.de.
Albert Kerbl GmbH 84428 Buchbach, Germany www.kerbl.com
17460
24 V / 50 Hz
250 W
Approx. 620 °C
Approx. 11 minutes
18 mm
4 m
Approx. 630 g