EINHELL GE-DP 900 Cut Instructions D'origine page 17

8.1 Cleaning the paddle wheel
Caution! Wear working gloves. Sharp blades! If a
lot of deposits collect in the housing, the bottom
part of the equipment must be dismantled as
follows:
1. Undo the 4 fastening screws of the base plate
at the intake cage (Figure 3).
2. Clean the paddle wheel with clear water.
3. Assemble in reverse order.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging.
Anl_GE_DP_900_Cut_SPK13.indb 17 Anl_GE_DP_900_Cut_SPK13.indb 17
GB
- 17 -
02.11.2021 14:20:55 02.11.2021 14:20:55