AUTO-HAK W13 Instructions De Montage

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
13
12
C
6
1
4
B
7
A
11
This towbar is designed to assembly in following cars:
SUZUKI SWIFT 3-5 doors, produced since 1989 till 09.1996 and since
10.1996 till 2003, catalogue number W13 and is prepared to tow trailers
max total weight 1000 kg and max vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and correct
exploitation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
13
12
6
C
5
10
8
9
D
2
3
From manufacturer
1. Disassemble the bumper.
2. Take out the noise mat from the boot.
B
7
A
3. On the left and right side in the boot are plastic pins (diameter 11mm). On this pins put
11
elements pos. 6 (pins in pos. A hole) – see fig. 2. Next drill holes through holes pos. 2
and 3, use bit Ø11 mm, drill straight through.
4. Put bolts M10x40 through holes(pos. C in element pos. 6 and next from below of car
sandwich element pos. 4 from the left side (screw loosely), from the right side
20
sandwich element pos. 5 (screw loosely too).
- to easier install get lower the muffler (take off from rubber handles)
5. Through holes pos. B (in elements pos. 6) put bolts M10x30 and screw it with floor
and element pos. 7.
6. In this way prepared elements (pos. 4 and 5) put main bar of the towbar (pos. 1) and
fix it using bolts M12x30 (loosely).
7. Through holes pos. D fix with original tow handle using distance plain washers
Ø58xØ12x6 pos. 8.
8. Fix all bolts according to the torque shown in the table.
9. Reassemble the bumper after cut out required fragment in bottom edge.
10. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts M12 x 70mm (pos. 9) from
equipment.
11. Connect electric wires according to the instruction of the car. (Recommend to make at
authorized service station)
12. Complete the paint coating damaged during installation.
After install the towbar you should get adequate note in registration book (at authorised
service station).The car should be equipped with:
•
Indicators
•
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always kept clear and
conserve with a grease.
The instruction of the assembly
plastic pins
Fig.2 Element's distance
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE