VITRA AutoClean Metropole Mode D'emploi page 7

Points to Consider when Using Auto Clean Washbasin
8. It is important not to put abrasive substances (highly acidic-basic substances, some
chemicals etc.) in the reservoir because they may damage the gaskets in the reservoir
and shorten the product life.
9. The lid of the AutoClean reservoir can be opened by hand. It is necessary to remember
that your children can open the lids of liquid detergent reservoirs and access to its
content, so you must protect them from these risks.
10. AutoClean detergent reservoir capacity is about 1 lt.
11. Operating temperature: +4°C to +40°C.
12. Washing duration and performance may vary depending on the installation pressure.
The useable installation pressure should be in the range of 2.5 – 6.5 Bar.
13. It is advisable to periodically replace the detergent dosing element every 3 months.
Potential problems about functioning of the system and solutions.
1- If the detergent is not dosing
- Check the jet pump and clean it if necessary.
- Check the connections of the jet pump and make sure that there is no air leakage in the
system.
- Make sure that there is enough liquid detergent in the detergent reservoir.
2- If the system is not doing a full washing
- Check the installation pressure. The pressure should be between 2.5 and 6.5 bar.
- Make sure that there is enough liquid detergent in the detergent reservoir.
- Check the washing rosette and eliminate blockages which prevent the passage of the
liquid.
6
EN