Assembly - Echo EGi-4000 Manuel D'utilisation

FEATURES
Reset Button
The reset button is used to restore power if an overload oc-
curs. To restore power, remove the last electrical load added
then press the reset button.

ASSEMBLY

Unpacking
This product requires assembly.
 Carefully cut the box down the sides then remove the
machine and any accessories from the box. Make sure
that all items listed in the Loose Parts List are included.
NOTE: This machine is heavy and requires a minimum of
two people to lift. To avoid back injury, lift with your legs
and not your back.
WARNING
Do not use this product if any parts in the Loose Parts
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer in-
stallation. Use of a product that may have been improp-
erly assembled could result in serious personal injury.
 Inspect the unit carefully to make sure no damage oc-
curred during shipping.
 Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-432-ECHO (3246) for assistance.
WARNING
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING
Do not attempt to modify this product or create ac-
cessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible seri-
ous personal injury.
WARNING
Do not attempt to operate the generator until assembly
is complete. Failure to comply could result in possible
serious personal injury.
12
USB Ports
The two 5 Volt, 2.1 Amp USB-dedicated charging ports will
charge most USB-compatible devices.
Loose Parts List
See Figure 2.
The following items are included with the generator:
Key
No. Description
1 Wheel ................................................................... 2
2 Wheel Cover ......................................................... 2
3 Axle Bolt ............................................................... 2
4 Washers ................................................................ 2
5 Hitch Pin ............................................................... 2
6 Foot Bracket ......................................................... 2
7 Bolt ....................................................................... 4
8 Lock Nut ............................................................... 4
9 Engine Lubricant .................................................. 1
Paper Funnel (not shown) .................................... 1
Operator's Manual (not shown) ............................ 1
Tools Needed
See Figure 3.
The following tools (not included or drawn to scale) are
needed for assembly:
 Socket Wrenches and/or Combination Wrench
NOTE: Do not put fuel or lubricant in the generator before
installing the feet and wheels.
Installing Feet
See Figure 4.
 Locate the following items:
2 foot bracket
4 lock nuts
4 bolts
 Insert bolts through foot bracket, then through the cross
brace as shown.
 Thread lock nuts onto bolts and tighten one full turn past
snug.
NOTE: Be careful not to overtighten so that foot mate-
rial collapses.
 Repeat with remaining foot.
English
Qty.