Kenwood IH100 Mode D'emploi page 6

troubleshooting guide
problems
After the appliance is plugged in
and the power button is pressed,
no indicators are lit
The power button indicator lights
up, but heating does not start
when power control is adjusted
Heating stops suddenly
during operation
In timer mode, the timer is set and
the on/off button is flashing but
heating does not begin.
Failure codes occur:
E:03 E:06
E:07 E:08
E:01 E:02 E:04 E:05 E:0b E:0C
suggestions
• Check that the plug is inserted correctly
and that the power is switched on.
• Where fitted check the plug fuse.
• Check that pan is present
• Check suitability of the pan
• Check that pan is centrally located
• Check power supply to the appliance
• Check the air entry or the air vent is
not blocked
• Check the timing period has not ended
• Check the appliance has not overheated
or entered error mode – unplug, allow to
cool and try again later
• Increase the power with the power
control
• Appliance may have overheated/boiled
dry. Unplug the appliance, allow to cool
and try again later
• Fluctuation in mains supply. Unplug the
appliance, allow to cool and try again
later
• Send it to a service facility for repair
6