Kenwood IH100 Mode D'emploi page 4

3 Place the pan centrally onto the
induction hob, within the pan guide -
shown by the graphic on the hob
plate .
4 Select the desired power setting with
the power control
begin.
●
To adjust the power, turn the power
control anticlockwise to decrease the
power and clockwise to increase the
power. There are 6 power settings.
●
Note: When the induction hob is
working, there will be a high
frequency intermittent sound and the
fan will operate. This is normal.
5 Turn off the induction hob when you
have finished cooking by pressing
the on/off button.
●
The fan will continue to operate after
the appliance has been switched off.
●
As this induction hob operates
slightly differently to a traditional hob,
some adjustments to the expected
cooking times and temperatures
may be necessary to achieve the
desired results.
hints
●
To reduce the cooking time, you can
turn the power control to the max
position when you turn the appliance
on. After a short time you can set
the power control to the required
position.
●
After a short period of use,
experience will teach you which
setting is the right one for your
needs.
●
Pan contents heat more quickly with
an induction hob.
and heating will
4
timer mode
1 When the timer button
it will light up, the appliance will
beep, the LED display
shows "00:00". Set the time using
the "+" or "-"
increase the time by 1 minute, "-"
will decrease the time by 1 minute.
To quickly set the time in 10 minute
increments hold the "+" or "-" button
down. This should be done within 5
seconds of pressing the timer button
or the LED display will default back
to ––:––. The timer range is
1 minute - 3 hours.
2 Once the timer has been set the
LED display will flash. Select the
desired power level within 5 seconds
(if not timing will not begin and the
appliance will automatically turn off
within 2 minutes). The display will
then count down (indicated by the
colon flashing) and heating will
begin.
3 After the set time has been reached,
the appliance will turn off.
●
To cancel timing during the count
down, press the timer button. It will
continue heating unless it is
switched off.
safety features
●
The induction hob will turn off if it is
not operated in two minutes.
●
In use, unless a suitable pan of at
least 12cm diameter is used a beep
will sound for approximately 1
minute. If an appropriate pan is not
placed onto the surface in this time
the induction hob automatically turns
off.
●
If the appliance overheats or pans
boil dry, the induction hob
automatically enters a protective
condition where its heating is then
regulated. If the overheating
continues, the appliance may display
a protection code (see
troubleshooting guide).
is pressed
flashes and
button, "+" will