Publicité
5.
TUNING THE STEERING TRIM
STEERING TRIM BUTTONS
Gently pull the trigger to allow your car to run slowly.
Meantime, tune the steering trim to allow the front
wheels to be aligned by pressing the left or right
buttons.
6.
TUNING THE THROTTLE TRIM
THROTTLE TRIM BUTTONS
Throttle Trim is used to set the idle speed of the car,
by pressing the left or right buttons.
LED INDICATOR:
• When using the trim keys the G.LED will flash slowly
for short presses and quickly on long presses.
• When the adjustment value is at the midpoint,
the G.LED will flash twice slowly.
• When the adjustment value is at the end of either + or - ,
the trim adjustment is at its maximum and as such G.LED will not flash.
7.
TO TUNE THE STEERING DUAL RATE CONTROL DIAL
STEERING D/R KNOB:
The buttons marked "ST/DR" is for servo travel
adjustment. You should adjust this to give maximum
steering without straining the servo.
Adjustment range: 0-120%(the default is 100%),
the step is 5%.
ST.D / R + : increase servo travel.
ST.D / R – : decrease servo travel.
LED INDICATOR:
• When using the trim keys the G.LED will flash slowly on short presses and
quickly on long presses.
• When the adjustment reaches the end point the G.LED will no longer flash.
8.
STEERING/THROTTLE REVERSE
This function is used to adjust each channels direction of movement in relation to
it's input .
The ST.REV/TH.REV switches are the reverse buttons for CH1 and CH2. If the
switch is up it indicates reverse, down indicates normal..
FTXOB3PassoManual.indd 9
FTXOB3PassoManual.indd 9
RUNNING YOUR CAR
STEERING
THROTTLE TRIM
STEERING D/R
9
19/07/2021 12:10
19/07/2021 12:10
Publicité
