Publicité
Les langues disponibles
Les langues disponibles
Original indicators will be definitively removed with the Ermax plate holder.
Fitting kit
Metallic support
ABS holder
Assembly
1. Dismantling of the side handles, saddles and the rear upper fairing.
- Unscrew the 2 screws holding the rear side handles (left and right sides).
Pay attention to not let fall and to get back the 2 spacers placed behind these 2 screws.
Lateral fitting screws
- Remove the rear saddle and the toolbox.
Unscrew the 2 front saddle's fitting screws and take it off.
- Unscrew the 4 rear fairing's screws and remove this fairing by pushing it back slightly and moving it away in the
direction of arrows (see pictures).
- White arrows : location of the 4 fairing's screws.
- Green arrows : push slightly in the arrows' direction to
release the fairing's clips.
- Red arrows : push aside the fairing where indicated by arrows
and in their direction to remove it.
2. Dismantle of the rear mudguard.
- Unclip the rear lower fairing at the level of the driver seat so as to release it on the 2 pins' sides : push outward on
both sides.
White arrow : lower fairing.
Red arrow : pins.
- Release the right fairing so as to disconnect the indicators terminals (black terminal and grey terminal). Disconnect
the plate lighting terminal placed at the taillight level too (black terminal).
- Unscrew the 4 fitting screws holding the mudguard : this mudguard is also maintained by 2 Phillips screws that
prevent from his dropping.
Think to take blinkers.
- 4 BHc screws Ø6x40
- 4 plastic washers Ø6
- 4 steel washers Ø6
- 4 Nylock nuts Ø6
- 4 plastics spacers Ø6x17
- 1 reflector holder SDC02
Spacers to get back
Screw holding the
rear mudguard.
FITTING INSTRUCTIONS
ERMAX PLATE HOLDER
ADAPTABLE ON Z 1000 SX 2011 → ∞
Estimated fitting time : 1h30
- 4 BHc screws Ø5x10
- 4 plastic washers Ø5
- 4 steel washers Ø5
- 4 Nylock nuts Ø5
- 1 SUP09 metallic support
Front saddle's
fitting screw
Publicité
