Publicité
Les langues disponibles
Les langues disponibles
6. Making ice
Put the ice dishes, filled with water, on the place provided for them on the evaporator. To make ice
quickly set the thermostat to its highest setting. It is easier to take the ice cubes out if you hold the dish
under a running tap.
7. Lightning
The interior ligth, working on mains, is switched by a sensor.
If a bulb has to be replaced, proceed as follows (fig. 3):
1. Pull out mains plug !
2. Remove cover of the lamp using a small srew driver (A)
3. Snap out the reflector at 4 positions (B)
4. Pull out reflector
5. Pull off the cabling and and clips out the defective bulb (C).
6. Put in a new bulb and reconnect the cabling
Important: Reconnect the cabling as shown in (D) !
7. Re- install reflector and lamp cover
8. Customer service, spares
Spare parts are obtainable from the agent for your area. When ordering spares, state serial No. and
description of model (see data plate).
9. Some useful hints
a) Check that the miniCoool is in an accurately horizontal position
b) Check that the air flow round the absorber unit (incoming and outgoing air).
c) If the frigde is not woking, check whether it is properly plugged in and check the fuse.
ATTENTION:
Do not store explosive substances, e. g. lighter fuel, petrol, ether, or the
like in the miniCool.
The absorber unit at the back of the appliance produces heat in operation. The
fridge has to be place in such a way, that an accidental touch of the unit is
impossible.
10. Technical Data
Model
Cabinet exterior
Volume (litres)
refrigerated/ non refrigerated60 / -
(H x W x D)
Electric rating (W)
Power consumpt. kWh/ 24h* 1,45
Net weight approx. (kg)
* Power consumption at an anual ambient temperature of 25 °C
Technical details may change without notice
EAW 3220
Free-standing
Metal
60
563 x486x474
80
23
4
Publicité
