Télécharger Imprimer la page

CLIMASTAR OPTIPLUS Notice D'instructions page 7

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
5.2- CONFIGURATION OF SETTING TEMPERATURE
Once the unit is ON, press
to select the desired temperature. Depending on the temperature selected, light displayed is different; see
images below.
18 Grad
5.3 SELECT THE OPERATION MODE
There are 4 operating modes:
 Manual.
 Timer ON  OFF
 Timer OFF  ON
 Replay.
Manual Mode
The user determines the setpoint temperature.
To select temperature, press
Timer ON  OFF Mode
The device will work at the preset temperature as per user's configuration
To select the temperature, press
Press  to select the operating time. By pressing  repeatedly, operating hours or a combination of operating hours will be selected.
E.g.
To deactivate the timer function press  repeatedly until the time LEDs are deactivated
Timer OFF  ON Mode
The device will stop working as per user's configuration.
On starting the device again, press
Press
during 2 seconds to switch to OFF mode.
Press  to select the switch-off time of the device. Press and hold  repeatedly to select the operating hours or the combination of
operating hours of the device. E.g.
To deactivate the timer function press  repeatedly until the time LEDs are deactivated.
Replay Mode
Press
to select the desired temperature.
Press  to select the operating cycle. By pressing it repeatedly, programmed hours or a combination of programmed hours will be
selected.
To select the replay mode, press for a few seconds, time lights start to flash, replay mode is activated.
Programming time starts as soon as it is set. E.g.
If it was set at 8 a.m., the heater works as shown below.
Press  once to deactivate the replay mode.
5.4 BLOCK THE DEVICE
This function enables to block the controls. To set this function, press
5.5 LED DISCONNECTED
19 Grad
22 Grad
repeatedly until the light activates on the desired temperature (see figures 5.2).
The unit is programmed at 21ºC during 5 hours.
to select the temperature to reach.
The device is disconnected during 5 hours
The unit is set to connect and disconnect every 4 hours.
21 Grad
24 Grad
and  simultaneously. To unblock, do the same.
7

Publicité

loading