Craftsman CMCD700 Guide D'utilisation page 11

Fig. F
7
LED Work Light (Fig. A)

CAUTION: Do not stare into worklight. Serious eye
injury could result.
When drill driver is activated by pulling the trigger
switch , the integrated LED work light
3
automatically illuminate the work area.
nOTE: The work light is for lighting the immediate work
surface and is not intended to be used as a flashlight.
Screw Driving
• For driving fasteners, the forward/reverse button should
be pushed to the left.
• Use reverse (button pushed to the right) for
removing fasteners.
nOTE: When moving from forward to reverse, or vice versa,
always release the trigger switch first.
Drilling (Fig. A)
• Select the desired speed/torque range using the speed
selector to match the speed and torque to the
6
planned operation. Turn the collar
nOTE: If drilling thin material, use a wood "backup"
block to prevent damage to the material
• Use sharp drill bits only.
• Support and secure work properly, as instructed in the
General Power Tool Safety Warnings.
• Use appropriate and required safety equipment, as
instructed in the General Power Tool Safety Warnings.
• Secure and maintain work area, as instructed in the
General Power Tool Safety Warnings.
• Run the drill very slowly, using light pressure, until the
hole is started enough to keep the drill bit from slipping
out of it.
• Apply pressure in a straight line with the bit. Use
enough pressure to keep the bit biting but not so much
as to stall the motor or deflect the bit.
• Hold the drill firmly with two hands, one hand on the
handle, and the other gripping the bottom around the
battery area or the auxillary handle if provided.
•
•
•
•
Drilling in Wood
Holes in wood can be made with the same twist drill bits
used for metal or with spade bits. These bits should be
sharp and should be pulled out frequently when drilling to
clear chips from the flutes.
Drilling in Metal
Use a cutting lubricant when drilling metals. The exceptions
are cast iron and brass which should be drilled dry. The
cutting lubricants that work best are sulfurized cutting oil
or lard oil.
will
8
Drilling in Masonry
Use carbide tipped masonry bits. Refer to Drilling section.
Keep even force on the drill but not so much that you crack
the brittle material. A smooth, even flow of dust indicates
the proper drilling rate.
MAINTENANCE

Accessories

to the drill symbol.
5
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569.
Versatrack™ (Fig. G)


DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF
AND ON IN AN ATTEMPT TO START IT. DAMAGE TO THE
DRILL CAN RESULT.
Minimize stalling on breakthrough by reducing pressure
and slowly drilling through the last part of the hole.
Keep the motor running while pulling the bit out of a
drilled hole. This will help reducejamming.
Make sure switch turns drill on and off.
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
WARNING: Since accessories, other than those
offered by CRAFTSMAN, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental can cause injury.
WARNING: To reduce the risk of serious personal
injury, do not use a damaged Versatrack™ hang hook
or Versatrack™ Trackwall. A damaged Versatrack™
hang hook or Versatrack™ Trackwall will not support
the weight of the tool.
English
9