Application; Operation - HENX H36CF900HE Mode D'emploi

English
a. Align the groove in the tube with the
knob on the blower housing. Push the
tube onto the blower housing until the
latch snaps into place (See Fig. A & B).
b. To remove the tube, press and hold the
tube-release button to disengage the
latch, then pull the tube straight from
the blower (See Fig. C).
Know your blower (See Fig. D)
9.3
The safe use of this product requires and
understanding of the information on the
tool and in this instruction manual as
well as knowledge of the project you are
attempting. Before use of this product,
familiarize yourself with all operating
features and safety rules.
Control Panel Power Indicator, On/Off
Button, Speed control
Trigger Starts or stops the
blower
Lock-on knob Lock the speed on
without keeping fingers
on the
Battery-Release Releases the battery
Button pack from the blower.
Over mold Ergonomic handle with
Handle overmold improves
comfort and grip.

10. Application

You may use this product for the purposes
listed below:
Clearing hard surfaces such as driveways
and walkways
Keeping decks and driveways free from
leaves and pine needles

11. Operation

WARNING: Do not allow familiarity with this
product to make you careless. Remember
that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING: Always wear eye protection with
side shields, along with hearing protection.
Failure to do so could result in objects being
thrown into your eyes and other possible
serious injuries.
16
WARNING: Do not use any attachments
or accessories not recommended by
the manufacturer of this product. The
use of attachments or accessories not
recommended can result in serious
personal injury.
Before each use, inspect the entire product
for damaged, missing, or loose parts, such
as screws, nuts, bolts, caps, etc. Tighten
securely all fasteners and caps and do not
operate this product until all missing or
damaged parts are replaced.
To instal/remove battery pack (See
11.1
Fig. E)
Charge before first use.
WARNING: Always remove the battery pack
from the product when you are assembling
parts, making adjustments, cleaning, or
when not in use. Removing the battery pack
will prevent accidental starting that could
cause serious personal injury.
a. Installing
Align the ribs of the battery pack with the
mounting slots in the blower's battery port.
Press the battery pack down until it snaps
into position.
b. Removing
Remove the battery pack from the blower.
WARNING: Always take care to note the
location of your feet, children, or pets when
pressing the battery-release button. Serious
injury could result if the battery pack falls.
Press the battery-release button; the battery
pack will disengage from the latch and
the ejection mechanism will assist with
removal.
Starting/Stopping the blower (See
11.2
Fig. F)
a. To start the blower, press power on
button then press the trigger.
b. The blower will begin to run.
To stop the blower, release the trigger,
c.
press power off.
Adjusting the air velocity (See Fig. F)
11.3
a. The blower is equipped with stepless
speed regulation to control the air
speed.