EN INSTRUCTIONS AND MODE OF USE
84
A.
B.
A.
B.
Fig. 17: Programming the coffee
extraction button.
PERSONALISED SETTINGS
The control panel buttons can also be used to personalise the dosages of
the different drinks.
Note: The volume of the espresso extraction button is not programmable.
Programming the coffee extraction button.
Note: The pre-defined factory volume for the coffee extraction button is
around 45cc.
• T o alter the volume of your beverage, ensure the machine is ON (see Fig.5),
check whether there is any water in the water tank and wait until the
control panel buttons indicate "Ready to use" (see Fig. 7).
• Then press the coffee extraction button until the indicator lights of the
C.
espresso and the tea extraction buttons start blinking.
Press the coffee extraction button (see Fig. 17).
The indicator lights of the espresso and the tea extraction buttons go
C.
out.
Note: If the user does not press again the coffee extraction button after 1
minute, the equipment will revert automatically to the "Ready to use" mode.
• As soon as extraction has reached the desired dosage, press the
coffee extraction button again and the operation is complete.
The equipment memorises this volume and will start extracting it until
new programming has been defined.
• After completing extraction, the equipment returns to "Ready to use"
mode (see Fig. 7).
Note: If the user fails to press the extraction button to complete the
operation, the equipment will automatically assume the maximum
volume of 200cc.