Before Use; Extension Table - SOLAC SW8240 Mode D'emploi

- If the model of your appliance does not have the accessories de-
scribed above, they can also be bought separately from the Technical
Assistance Service.
Instructions for use

Before use:

- Make sure that all the product's packaging has been removed.
- Some parts of the appliance have been lightly greased. Consequently,
the fi rst time the appliance is used a light smoke may be detected.
After a short time, this smoke will disappear.
- Prepare the appliance according to the function you wish to use:
Getting ready to sew
Connect the machine to the power supply
- Before connecting the power, make sure the voltage and frequency of
your electrical power conform to the machine. Make sure the power
switch is in the "off" position. Fit the nonreversible plug into the cord
socket and plug the machine in to the power supply.
- Then turn the power switch on
Foot control.
- Sewing speed can be varied the foot control.
- The harder you press on the control; the faster machine runs.
Extension table (accessory box) Extension table (accessory box)

Extension table:

- The extension table provides added sewing surface and can be easily
removed for free arm sewing.
For free arm sewing:
- The extension table provides added sewing surface and can be easily
removed for free arm sewing.
For attaching table:
- Push the extension table until its lugs fi t into the machine
Accessory box.
Sewing accessories are conveniently stored under the extension
table.
To snap on and snap off the presser foot
To snap off:
- Turn the hand wheel toward you to raise the needle to its highest
position. Raise the presser foot
- Press the lever on the back of the foot holder.
- The presser foot will drop off.
To snap on:
- Place the presser foot so the pin on the foot lies just under the groove
of the holder.
- Lower the foot holder to lock the foot foot in place.
Changing needle chart: