Package Content - MELICONI HP300 professional Mode D'emploi

1. Receiver RF headphones
2. RF transmitter (recharging base)
3. AC Power unit, 6V, 300 mA
4. Audio cable 3.5mm to 3.5mm
5. Two rechargeable AAA batteries
6. Instructions
1. TRASMITTER (FIG. 1)
Before connecting the cables, unplug the devices from the electric grid
- Connect the power cord to the DC IN input connector located on the back of the transmitter.
- Use the audio cable to connect the audio jack on the back of the transmitter to the audio output located on a TV or
other audio video device. Warning: if the device is not equipped with a 3.5mm audio output, the scart output can be
used alternatively by means of a suitable adapter (not supplied).
- Connect the headphones power unit and the connected audio devices to the electric grid.
- Turn on the transmitter.
The RED LED of the transmitter will turn on as soon as the system is powered and the audio cable connected to a
signal source. If the LED remains off, turn on the connected audio source and increase output volume until the red LED
turns on.
2. HEADPHONES (FIG. 2)
Headphones parts
A. On / Off switch
B. On / Off LED
C. Volume selector
D. Auto Scan button
E. Auto Scan LED
F. Battery cover
G. Battery cover opening
- Remove the battery cover located on the left (L) pad.
- Insert two AAA rechargeable batteries. Observe their correct polarity.
- Close the battery cover.
- Turn off the headphones and place them on the transmitter (base) so that the batteries can be charged for 24 hours
prior to fi rst use. Ensure that the base lights on, indicating correct contact between headphones and recharging
socket.
To start the system and listen to the signal from the audio source, observe the following steps:
- Turn on the audio source connected to the transmitter.
- Turn on the headphones.
- Wear the headphones, making sure that the right pad, marked R, is on the right ear, and adjust the volume in order to
achieve the wanted sound level.
- If the signal is disturbed, press the "Auto Scan" button on the headphones to activate the automatic search of the best
transmission channel.
Notes:
Now you can move freely from one room to another without interference. If interference occurs (signal interruptions),
press the "Auto Scan" button once to fi nd a channel with better reception. If a satisfying frequency cannot be found,
change the channel setting on the transmitter (fi gure 1 A), then press the "Auto Scan" button on the headphones to fi nd
the corresponding channel.
Auto shut-off function (energy saving):
The transmitter will automatically turn off after approximately four minutes if there is no audio signal or if the signal
received from the audio source is too weak for suitable reception. This will protect the transmitter and save energy.
However, if the signal returns to an acceptable level, the transmitter will turn on again automatically.
14

Package content

Installation
Use