Table des Matières
Publicité
204
E
2 The subject was out of the working range of the flash.
[ Shoot within the flash working range. (P. 92)
3 The flash mode was set to the Off mode.
[ Check the flash mode before shooting. (P. 94)
4 The subject was too small and was backlit.
[ Set the flash to Fill-In mode. (P. 94)
The picture is too bright.
1 The flash was set to the Fill-In Flash mode.
[ Set the flash mode to one other than Fill-In Flash.
(P. 94)
2 The subject was very bright.
[ Either adjust the exposure or point the camera away
from overly bright subjects. (P. 116)
The colors of pictures taken indoors look unnatural.
1 The lighting fixture(s) affected the picture.
[ Set the flash mode to Fill-In. (P. 94)
2 The subject is mostly dark.
[ Include white in the image or adjust the white balance.
(P. 122)
3 The white balance setting is wrong.
[ Adjust the white balance. (P. 122)
The picture has obscured edge(s).
1 The lens was partly blocked by a finger or the strap.
[ Hold the camera correctly, keeping your fingers and
the strap away from the lens. (P. 68)
2 The shooting distance was too close.
[ Use the LCD monitor. (P. 76)
Publicité
Table des Matières
