seeger SAC9000S Mode D'emploi page 13

Cooling
Select the "Cool" position to reduce the temperature:
Press the MODE button until the "Cool" indicator comes on.
Press the up/down button to select the temperature displayed on the screen (16°C
and 32°C)
Press the SPEED button until the desired ventilation speed is turned on.
To adjust the direction of airflow horizontally, manually adjust the ai flap.
To adjust the direction of airflow horizontally, manually adjust the air fin. Note: The air
conditioner automatically turns off when the ambient temperature is below the selected
temperature.
Heating (only SAC9000HS)
Press the MODE button until the "Heating" indicator illuminates.
Press the up/down button to set a temperature above the ambient temperature.
The fan speed can also be adjusted.
Note: For continuous operation, the drain pipe must be connected to the devise.
Ventilation
Press the MODE button until the "Fan" indicator turns on.
In ventilation mode, the ambient air is changed and not cooled.
Press the SPEED button to select the desired speed level.
Drying/Dehumidification
Press the MODE button on the control panel, the dry light will light up. Unable to select
fan speed. The user must connect the pipe to the drain at the bottom of the device. In
this mode, the fan speed is set to low and cannot be adjusted.
Sleep mode (this function can only be selected by the remote control).
Standby mode can be activated in cooling mode and heating mode.
In cooling mode:
-
After 1 hour, the preset temperature is increased by 1 ° C, after another hour by 1 ° C
again, etc.
In heating mode (only SAC9000HS):
-
After an hour, the preset temperature is reduced by 1 ° C, then again by 1 ° C after
13
ENG