Use
•
Placing the bonnet on to the cushion:
01. Turn the waxer/polisher over so that the cushion points
upwards.
02. Place a bonnet on to the cushion. Ensure that the bonnet is
central, sits tightly on the cushion and cannot rub on the
housing
.
•
Applying the wax/polish:
03. Always use a high quality product for waxing.
·
Follow the working methods given on the packaging.
04. Apply the wax/polish directly to the contact surface of the
bonnet.
·
In order to achieve a thin complete covering do not use
more material than is absolutely necessary. Too much
wax does not achieve a better finish and you will have
spent more time later removing the coating.
05. Spread the wax evenly over the bonnet. It should also cover
the bonnet edges.
•
Switching on and waxing /polishing the paintwork:
Note: The paintwork to be polished must be first thoroughly
cleaned and fully dry.
If necessary use a commercially available paintwork cleaner.
Use a product suitable for the demands on and condition of
your paintwork. Heavily oxidised paintwork requires a special
cleaner. You should use a combined product (cleaner + wax)
for this task.
10
GB
06. Turn the waxer/polisher over again and place it on the
surface to be polished.
·
Make sure that the mains lead cannot come into contact
with the waxer/polisher. Work more safely by guiding the
mains lead over your shoulder.
07. Check again that all the safety requirements have been
fulfilled.
08. Using both hands firmly grasp the two handles and switch on
the waxer/polisher by pushing down the switch
(see Fig. A).
09. Guide the waxer/polisher evenly over the paintwork
(see Fig. B).
·
ATTENTION: Do not press on the waxer/polisher! The
self-weight of the waxer/polisher applies sufficient
pressure for the waxing/polishing process.
·
Any difficult to reach corners or recesses may have to be
completed later by hand. Take the bonnet off the waxer /
polisher and use this bonnet for the corners and recesses.
•
Removing wax or polishing:
10. Use the second bonnet for final polishing or removing the
wax.
·
When working, always follow the instructions given for
the wax/polish.
Cleaning
·
Before cleaning the tool, pull out the plug out of the
mains socket.
·
Clean the housing with a slightly moist cloth. If necessary
use a mild cleaning agent.
·
Clean the bonnet by washing by hand in soapy water.
Use / Cleaning