Phase Linear UMP301 Manuel De L'utilisateur page 4

INSTALLATION INSTRUCTIONS
Installation Using a Kit
If your vehicle requires the use of an installation
kit to mount this radio, follow the instructions
included with the installation kit to attach the
radio to the mounting plate supplied with the kit.
1. Wire and test the radio as described in step
4 of "Using the Mounting Sleeve".
2. Install the radio mounting plate assembly to
the sub-dashboard according to the installa-
tion kit instructions.
3. Attach the support strap to the radio and
dashboard as described in step 6 of "Using
the Mounting Sleeve".
4. Replace the dashboard trim panel.
ISO Installation
This unit has threaded holes in the chassis side
panels which may be used with the original
factory mounting brackets of some Toyota,
Nissan, Mitsubishi, Isuzu, Hyundai and Honda
vehicles to mount the radio to the dashboard.
Please consult with your local car stereo
specialty shop for assistance on this type of
installation.
1. Remove the existing factory radio from the
dashboard or center console mounting.
Save all hardware and brackets as they will
be used to mount the new radio.
ISO INSTALLATION
2. Carefully unsnap the plastic frame from the
front of the new radio chassis. Remove and
discard the frame.
3. Remove the factory mounting brackets and
hardware from the existing radio and attach
them to the new radio.
CAUTION: Do not exceed M5 X 6 MM screw
size. Longer screws may touch and damage
components inside the chassis.
4. Wire the new radio to the vehicle as
described in step 4 of "Using the Mounting
Sleeve".
5. Mount the new radio assembly to the dash-
board or center console using the reverse
4
procedure in step 1 of "Using the Mounting
Sleeve".
Removing the Radio
To remove the radio after installation, remove
the trim ring by lifting in the center and pulling it
off from either side. Insert the removal keys
straight back until they lock, then pull the radio
out. If removal keys are inserted at an angle,
they will not lock properly and will not release
the unit.
REMOVING THE RADIO
UMP301