Krups XP5220 Manuel page 15

IFU Krups XP5220-XP5240 0828241B.qxd:0828241B
Problems
Water leaks under
the machine.
The pump is
unusually noisy.
The cups are not
filled equally.
Leaking filter holder.
Your espresso tastes
bad.
The machine does
not work
The steam wand
does not froth the
milk.
Possible causes
Internal leak.
Drip tray is not in the correct
position.
Drip tray has overflowed.
No water in the tank.
The tank is not properly
positioned.
The filter holder is clogged.
The filter holder is not
properly positioned.
The edges of the filter holder
are clogged with excess
ground coffee.
Pod improperly positioned in
the filter.
After descaling, the rinsing
was not performed properly.
The pump could not be
primed due to lack of water.
The water tank is not
properly positioned.
The frothing nozzle is
clogged or needs to be
descaled.
The milk is not cold or not
fresh enough.
The inner tube of the
frothing nozzle is not firmly
screwed in.
The shape of the container
is not appropriate for
frothing.
30/03/09 10:42
Solutions
Check the position of the tank. If the fault persists,
do not use the machine, contact an approved
service centre.
Check that the drip tray is pushed completely into
the machine (see section 7).
Carefully empty and rinse the drip tray, then replace
in the machine (see Section 7).
Stop the machine. Fill the water tank, replace in
the correct position, and turn the machine back on.
Replace the tank in the correct position.
Clean the filter holder (see section 7).
Lock the filter holder firmly in place.
Take care when filling the filter to brush excess
coffee off the edges before locking the filter
holder in place.
Check that the pod is properly centered in the
filter, with excess paper removed from E.S.E.
pods, and that none of the paper is hanging over
the edges of the filter.
Rinse the machine carefully after descaling (see
Section 8).
Fill the water tank and re-prime the pump (see
Section 4). Always check before starting a cycle
to see that there is sufficient water in the water
tank. Avoid allowing the tank to run dry when
operating the machine.
Replace the water tank in the proper position.
Carefully clean (see Section 7) or descale the
steam wand (see Section 8).
Use fresh, cold milk in a cold container.
Pasteurised or UHT milk is recommended. Whole,
lowfat, or skim milk can all be frothed. Try using a
different brand of milk.
Screw the inner nozzle firmly in place (see Section
7).
Use a small pitcher-shaped container with a small
diameter for best results. Also, chilling the
container before adding the milk will improve
results.
Page 9
English
9