Meec tools 019148 Manuel D'instructions page 12

EN
• Avoid accidental starting. Check that the
power switch is in the OFF position before
plugging in the power cord and/or the
battery, or lifting/carrying the tool.
Carrying a power tool with your finger on
the switch, or connecting a tool to the
mains supply when the switch is in the ON
position, increases the risk of accidents
and injuries.
• Remove adjuster keys/spanners etc.
before starting the tool.
• Do not overreach. Always maintain a firm
footing and good balance. This will ensure
you have better control over the tool in
unexpected situations.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
Wear safety glasses.
Safety class II.
For indoor use only.
TECHNICAL DATA
Rated voltage
Output
Temperature range
Cord length
DESCRIPTION
12
230 V ~ 50 Hz
150 W
400-500°C
1.2 m
Soldering iron for both large and small repairs.
The soldering tip is angled and replaceable.
1. Handle
2. Status light heating
3. Soldering tip
FIG. 1
USE
1. Check that the mains voltage corresponds
to the rated voltage on the type plate.
2. Plug the plug into a suitable power point.
3. Remove any oxide and all contaminants
from the workpiece.
4. Allow the soldering tip to warm up.
5. Tin the soldering tip.
6. Put the soldering tip on the workpiece.
7. Put solder in the contact point between
the soldering tip and the workpiece.
8. Allow the solder to melt and spread.
9. Lift the soldering tip and the soldering
wire off the workpiece at the same time.
WARNING!
• Put the product on its stand when not in
use.
• Wear safety glasses.
• Only use the product in a well ventilated
area.