Publicité
Les langues disponibles
Les langues disponibles
SAFETY INSTRUCTIONS
•
The product must only be used as it is
intended to be used and in accordance
with these instructions in order to comply
with the relevant safety standards.
The electrical installation must comply
with the applicable national regulations.
•
Dangerous voltage runs through the wires
in the product.
•
Disconnect the power supply before
installation and make sure it cannot be
reconnected by mistake.
•
Failure to follow all the instructions and
safety instructions can result in a risk of
fatal or serious personal injury.
•
Unpack and check the product and all the
parts for transport damage. Do not install
or use the product if it is damaged.
Take the product to an authorised service
centre to be checked, repaired or
adjusted.
•
Do not connect the power supply to the
product while still in the pack – risk of
material damage.
•
Switch off the power supply before
working on the product.
•
The product does not contain any parts
that can be repaired by the user.
•
Parts of the product get hot when in use
– risk of burn injury. Do not touch the
product until it has cooled.
ELECTRICAL SAFETY!
New installations and extensions to existing
systems should always be carried out by
an authorised electrician. If you have the
necessary experience and knowledge
(otherwise contact an electrician), you can
replace power switches and wall sockets,
fit plugs, extension cords and light sockets.
Incorrect installation can result in fatal injury
and the risk of fire.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
Safety class II
TECHNICAL DATA
Rated voltage
Output
Safety class
Protection rating
Colour rendering index
Colour temperature
Energy class
Luminous flux
Life span
Size
Weight
INSTALLATION
WARNING!
Parts of the product get hot when in use –
risk of burn injury. Do not touch the product
until it has cooled.
1.
Fit the bracket to the ceiling. The product
should be installed no more than seven
metres above the floor.
FIG. 1
2.
Connect the live wire and neutral wire
to the corresponding terminals on the
product.
FIG. 2
230 V ~ 50 Hz
24 W
IP20
80
3000 / 4000 / 6000 K
2500 lm
30000 h
Ø 33 x h 2.5 cm
1 kg
EN
II
F
11
Publicité
