Toparc 059962 Mode D'emploi page 9

Translation of the original instructions
TO UNFOLD THE WORKLIGHT FOR A FLAT MODE OPERATION
1. Firmly hold both clamps (3).
2. Swing open both sections of the Worklight casing all the way to a flat position.
3. Continue to apply force beyond the initial resistance to hear a "CLICK", locking both sections of the Worklight in a
flat position.
4. Both clamps (3) are spring loaded and can be extended or retracted for the light desired length.
ATTACHING THE LAMP TO THE WORKPLACE
1. Firmly Attach one of the clamps (3) to the intended surface.
2. Extend the other clamp (3) to adjust the light for the desired length.
3. Firmly mount the second clamp to the other part of the work space.
CARE AND MAINTENANCE
1. After use and before performing maintenance, unplug and disconnect the lamp from charger.
2. Make sure all of the lamp components are in place, and are in good working condition.
3. Wipe the unit with mild soap and a lint free wet cloth. Make certain to dry the unit entirely before storing it for
future use.
4. DO NOT disassemble the housing. There are no serviceable parts.
5. All rechargeable batteries discharge over time, and more rapidly at elevated and/or low temperatures. When the
unit is not in use, the internal battery shall be charged every 6 months.
6. SAFE BATTERY DISPOSAL - This product contains maintenance free, sealed, non-spillable battery, which must be
disposed of properly; recycle is required. Contact your local authority for disposal information. Failure to comply
with local, state and federal regulations can result in fines and/or imprisonment.
CONTACT YOUR LOCAL WASTE MANAGEMENT AUTHORITY TO DISPOSE OF THIS PRODUCT.
TROUBLESHOOTING
A. If the Product Does Not Operate
1. The internal battery may have been completely discharged - Charge the unit completely, following the previous
charginginstructions.
B.Worklight Does Not Operate
1. Check that the unit is fully charged. Recharge the lamp internal battery if necessary.
2. Make certain that the ON/OFF Power Button is firmly pressed to set the unit to ON position.*
C.The lamp does not charge
1. Check connection to the provided AC Charging Adaptor (Home Charger).
2. Check connection to the 12 Volt DC Charging Adaptor (Car Charger).
3. Check if there is power through the AC outlet or 12 VDC socket.
SPECIFICATIONS
Internal Rechargeable Battery: 3.7 Volt 4000 mAh Lithium ion
1000 Lumens SMD - High Intensity Mode: 1000 Lumens
500 Lumens SMD - Low Intensity Mode: 500 Lumens
White SMD: 120 LEDs
Low Intensity Mode Runtime: 8 Hours
High Intensity Mode Runtime: 4 Hours
Product Dimensions (extended): 11 x 10 x 133 cm
Product Weight: 1,7 kgs
UNDER BONNET LAMP 600L
EN
9