Sparex 28716 Manuel D'opérateur page 8

Replacing 9-Volt Alkaline Battery
NOTE: "LOBAT" will display when a switch is pressed and battery needs
replacement.
1. Remove battery door (A) from back of tester.
2. Attach leads (B) to 9 volt alkaline battery (C) terminals.
3. Attach battery door to tester.
B
C
Replacing Battery
Care, Maintenance and Storage
CAUTION: Never attempt to wear tester probe
on your belt. Serious injury could occur
from sharp tip of probe.
1. After each use, store tester in a clean, dry place.
2. Probe's metal tip should be wiped clean between each use for
best results. Clean both parts of metal tip from time-to-time with
fine steel wool and/or mineral spirits or alco-hol. A dirty tip can
cause lower test readings. Keep brass shiny for best results.
3. Never immerse probe in water.
4. Remove battery if tester will not be used for several months.
Service
A