Publicité
Les langues disponibles
Les langues disponibles
Installing the Foot Switch
Once an installation location has been decided,
perform the following steps:
1. Drill a 16.5mm (41/64 inch) hole through the
mounting surface.
2. Place one lockwasher (supplied in plastic bag) on
the foot switch threaded shaft.
3. Insert the threaded shaft up through the mounting
surface.
4. Adjust the hex nut until the exposed threaded
shaft is 12.7 mm (1/2 inch) above the top of the
mounting surface.
5. Place one lockwasher (supplied in plastic bag) on
the threaded shaft.
6. Screw the second hex nut onto the threaded
shaft, and tighten it to secure the foot switch in the
hole.
7. Screw the metal portion of the rubber cap onto the
threaded shaft and pop the boot over the switch
actuator shaft.
8. Screw the rubber cap down to secure it.
3
Publicité
