Publicité
Les langues disponibles
Les langues disponibles
Front Panel
EFX Time
16
This control adjusts the time of the particular reverb or delay.
Green Signal LED and Red Clip LED
17
The green Signal LED and red Clip LED are used to set the operating input level to the PV™10, PV™14,
and PV™20 effects processors. The signal level to the processor is affected by channel Fader, the Effects
Send and the Effects Send Master Controls. Start with the Master Control (20) set to 0 (12 o'clock) and
adjust the channel sends so that the signal LED lights and the clip LED blinks on occasionally, if at all.
The clip LED lights 6 dB below clipping. Pressing the EFX defeat mutes the effects signal and lights the
clip/mute LED.
EFX Return
18
Once the input level is set (see 17) use the EFX Return control to mix the effects processor output into
the main left/right outputs. Remember, a little reverb goes a long way.
MON Send Master
19
This is the master output level control for the monitor mix.
The output level sent to the Monitor Send jack (37) is con-
trolled by the channel Monitor Send controls (6) and by this
master control.
EFX Send Master
20
This is the master output level control for the EFX mix. The
output level sent to the EFX Send jack and the internal ef-
fects processor is controlled by the channel Fader (12), the
channel EFX Send controls (7), and by this master control.
The 0 position is the recommended setting for this control.
Headphone Level
21
This knob sets the headphone and control room output
levels. To avoid damage to your hearing‚ make sure to turn
the dial fully counterclockwise before using headphones.
Slowly turn the knob clockwise until you reach a comfort-
able listening level. Normally, the signal in the headphones
is the left/right signal. If the Tape to Control Room (26) is
engaged‚ the tape signal is also included.
LED Meters
22
Two eight-segment LED arrays are provided to monitor the
levels of the main left/right outputs. These meters range
from -30 dB to +19 dB. The 0 dB position on the meter corresponds to +4 dBu at the outputs.
Power LED
23
This LED indicates AC power is supplied to the unit‚ the power switch is on, and the unit is functioning
properly.
Phantom Power LED
24
This LED lights when the Phantom Power Switch (25) has been engaged.
19
20
23
24
25
26
27
29
30
10
0
MON1
0
HEADPHONE
3
3
3
3
SEND
6
6
5
5
15
15
40
40
10
10
dB
dB
0
5
MON2
TAPE/USB
3
4
6
3
SEND
TO MAIN
6
3
7
5
15
2
8
1
9
40
10
0
10
dB
EFX
0
3
3
SEND
L
R
6
5
15
CLIP
40
10
dB
+6
0
-3
POWER
-6
-12
-20
+48V
-30
PHANTOM
MASTER LEVEL
TAPE/USB TO
10
CTRL/HP
6
TAPE/USB
TO MIX
0
6
CONTOUR
12
20
USB
EQUIPPED
21
28
22
Publicité
