Télécharger Imprimer la page

Dometic FO200FT, FO200FTFE FO211FGT FO290TD, FO290TS FO291TD Installation Utilisation Entretien page 20

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
SPIT
Ignite the oven as described in the chapter OVEN. Turn the gas knob to the required position. Insert the drip tray with
the spit already installed as illustrated in FIG. 7 - PG. 134. Press the spit button to turn on the spit motor.
ROTATING PLATE
Position the drip tray with the rotating plate as illustrated in FIG. 8 - PG. 135. Press the purpose button to turn on
rotating plate motor.
GAS CYLINDERS/ BOTTLES
NEVER OPERATE THE APPLIANCE WITH GAS AND/OR AT GAS PRESSURES
DIFFERENT FROM THOSE INDICATED BY THE MANUFACTURER AS THIS COULD
CAUSE IRREGULAR AND INCORRECT OPERATION. THE MANUFACTURER
DECLINES ALL LIABILITY FOR THE INCORRECT OR IMPROPER USE OF THE
APPLIANCE.
The appliance runs off standard gas bottles which can be found in the country of use. The type of gas to use is clearly
marked on the packaging and on the specifications label affixed to the rear of the appliance. However always respect the
following instructions: gas bottles must always be located and positioned in the compartment provided for this purpose.
They must always be vertical and fitted with a pressure regulator and easily accessible and not obstructed. Do not
obstruct or impede access to the gas bottle to permit quick and easy access when replacing.
WARNING!: When replacing the gas bottle always take the following precautions:
a) close all gas knobs;
b) make sure there are no flames or fires in proximity of the gas bottle;
c) close the gas valve on the bottle to be replaced;
d) unscrew the pressure regulator on the empty bottle and remove the bottle from the purpose compartment. This
procedure is inverted for fitting a new bottle. Check for gas leaks using a non-corrosive fluid/solution. Do not use a
water and soap solution. NEVER USE A FLAME TO CHECK FOR GAS LEAKS;
e) ignite the burners to check they function correctly. If there are problems, call in an authorised gas service engineer.
AFTER APPLIANCE USE ALWAYS TURN OFF THE GAS TAP ON THE BOTTLE.
GAS LEAKS
We recommend the use of an electronic and homologated gas detector for checking for gas leaks.
If there is a smell of gas;
a) immediately open the windows and evacuate the vehicle or caravan;
b) do not turn on or off light switches or other electronic and electric appliances, do not light matches or lighters or
anything that could cause the gas to ignite;
c) put out any flames;
d) shut off the valve on the gas bottle or cylinder. Do not re-open this valve unless the gas leak has been identified and
eliminated;
e) contact a specialised gas service engineer.

Publicité

loading