e-conolight E-WKL Serie Manuel page 2

INSTALLATION INSTRUCTIONS
E-WKL Series
1500L and 5000L LED Portable Worklight
ASSEMBLY
1. Attach the lamp head to the stand by laying the lamp head face
down and positioning the stand against the U-shaped bracket on
the lamp head. See Figure 1.
2. Attach the lamp head to the stand by inserting the screw into the
bottom of the stand and through the U-shaped portion of the lamp
head. Secure together using one nut.
OPERATION
Adjusting The Light Direction
1. To adjust the lamp head, loosen the twist knobs on each side of
the lamp head. Then hold the top of the lamp head and move
forward or backward to desired position. Retighten the twist
knobs. See Figure 2.
2. To swivel the lamp head, loosen the nut that attaches the lamp
head to the stand and swivel the lamp head to the desired
position. Re-tighten the nut. See Figure 2.
NOTE: Tilt angle restrictions are as shown in Figure 2.
Turning The Lamp Head On
NOTE: Plug the worklight into a 120V outlet before you turn it on.
1. Press the On/Off switch on the lamp to turn the lamp on (–) and
off (o). See Figure 3.
MOUNTING TO TRIPOD
NOTE: Requires use of E-WKLTRIPODSMLBLU accessory kit.
1. Use the quick connect screw on the base of the stand to attach
worklight to the tripod.
NOTE: For more in depth instructions, see installation instructions
provided with tripod kit.
FIGURE 1
U-Bracket
Stand
Quick
Connect
Nut
Screw
Lamp Head
www.e-conolight.com
Document:
Created By:
FIGURE 2
Nut
FIGURE 3
Lamp Head
| 888.243.9445 | FAX: 262.504.5409
Date
DCR#
Twist Knob
Twist Knob
Stand
30° 45°
On/Off
Switch