7 Transportation, storage and disposal
7.1 Transportation
The supplied Li-ion batteries obey the
Dangerous Goods Legislation requirements.
•
Obey all applicable national regulations.
•
Obey the special requirement on package
and labels for commercial transportations,
including by third parties and forwarding
agents.
•
For how to remove the battery, refer to
the complete Operator's manual on
www.husqvarna.com.
7.1.1 How to lift and move the product
To safely move from or within the work area:
1.
Push the STOP button to stop the
product. If security is set to the medium or
high level the PIN code has to be entered.
The PIN code contains four digits and is
selected when you start the product for
the first time. Refer to complete
Operator's manual.
2.
Switch off the product with the main
switch or the ON/OFF button.
105
305
3.
Carry the product by the handle under the
product with the blade disc away from the
body.
24 - Transportation, storage and
disposal
310/315/315X
420/430X/440/450X
105
305/310
315/315X
7.2 Winter storage
7.2.1 The robotic lawn mower
The product must be cleaned carefully before
putting it away for the winter. Refer to
Cleaning on page 21 .
CAUTION:
The battery must be
charged fully before winter storage.
If the battery is not fully charged it
can be damaged and in certain
cases be rendered useless.
Place the product in the charging station with
the hatch open until the battery icon in the
display shows that the battery is fully charged.
Switch off the product with the main switch or
the ON/OFF button.
Check the condition of wear items such as
blades and bearings in the rear wheel. Rectify
if necessary to make sure the product is in
good condition prior to next season.
Store the product standing on all wheels and
place it in a dry, frost-free environment,
preferably in the products's original packaging.
You can also hang the product on a
Husqvarna original wall hanger. Contact your
Husqvarna representative for more information
about available wall hangers.
7.2.2 The charging station
Store the charging station and power supply
indoors. The boundary wire and the guide wire
can be left in the ground.
1.
Disconnect the charging station's power
supply from the mains.
1418 - 004 - 10.03.2020
420/430X
440/450X