Important Safety Information; Fire Hazard; Explosion Hazard - Hatco RWM Série Manuel D'installation Et D'utilisation

Read the following important safety information before using this equipment to avoid
serious injury or death and to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded
electrical receptacle of the correct voltage,
size, and plug configuration. If plug and
receptacle do not match, contact a qualified
electrician to determine and install proper
voltage and size electrical receptacle.
• Turn OFF power switch, unplug power
cord, and allow unit to cool before
performing any cleaning, adjustments, or
maintenance.
• Unit is not weatherproof. Locate unit
indoors where ambient air temperature is
a minimum of 21°C (70°F).
• DO NOT submerge or saturate with water.
Unit is not waterproof. Do not operate if
unit has been submerged or saturated
with water.
• Do not steam clean or use excessive
water on unit.
• This unit is not "jet-proof" construction. Do
not use jet-clean spray to clean this unit.
• Do not clean unit when it is energized or
hot.
• Do not allow liquids to spill into unit.
• Do not pull unit by power cord.
• Do not allow power cord to hang over
edge of counter.
• Discontinue use if power cord is frayed or
worn.
• Do not attempt to repair or replace a
damaged power cord. Cord must be
replaced by Hatco, an Authorized Hatco
Service Agent, or a person with similar
qualifications.
• This unit must be serviced by qualified
personnel only. Service by unqualified
personnel may lead to electric shock or
burn.
• Use only Genuine Hatco Replacement
Parts when service is required. Failure
to use Genuine Hatco Replacement
Parts will void all warranties and may
subject operators of the equipment to
hazardous electrical voltage, resulting
in electrical shock or burn. Genuine
Hatco Replacement Parts are specified
to operate safely in the environments in
which they are used. Some aftermarket
or generic replacement parts do not have
the characteristics that will allow them to
operate safely in Hatco equipment.
Form No. WMCEM-0519

IMPORTANT SAFETY INFORMATION

FIRE HAZARD:

• Locate unit a minimum of 51 mm (2")
from combustible walls and materials.
If safe distances are not maintained,
discoloration or combustion could occur.
• Do not obstruct air ventilation openings
on outer housing of unit. Unit combustion
or malfunction may occur.
EXPLOSION HAZARD: Do not store or use
gasoline or other flammable vapors or
liquids in the vicinity of this or any other
appliance.
Make sure all operators have been instructed
on the safe and proper use of the unit.
This unit is not intended for use by children
or persons with reduced physical, sensory,
or mental capabilities. Ensure proper
supervision of children and keep them away
from the unit.
Never leave unit unattended during use.
Do not use unit for any purpose other than
for which it is designed.
This unit has no "user-serviceable" parts.
If service is required on this unit, contact
an Authorized Hatco Service Agent or
contact the Hatco Service Department at
+1-414-671-6350.
BURN HAZARD:
• Some exterior surfaces on unit will get
hot. Avoid unnecessary contact with unit.
• Do not come in contact with cooking
plates during operation. Both plates are
very hot.
• Allow unit to cool before performing any
cleaning, adjustments, or maintenance.
Locate unit at proper counter height in an
area that is convenient for use. Location
should be level and strong enough to
support weight of unit and contents.
3
WARNING
CAUTION