Peavey FX Serie Guide D'utilisation page 19

Rear Panel
Power Switch
62
Pressing the power switch supplies power to the unit.
Removable Power Cord
63
This receptacle is for the IEC line cord (included) that pro-
vides AC power to the unit. Connect the line cord to this
connector and to a properly grounded AC supply. Damage
to the equipment may occur if an improper line voltage is
used (see voltage marking on unit).
62
64
63
Never remove or cut the ground pin of the line cord plug. The console is supplied with a properly rated
line cord. If lost or damaged, replace this cord with one of the proper rating.
NOTE FOR UK ONLY:
If the colors of the wires in the mains lead of this unit do not correspond with the colored markings iden-
tifying terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must be
connected to the terminal marked by the letter E, or by the Earth symbol, or colored green or green and
yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter
N, or colored black. (3) The wire that is colored brown must be connected to the terminal that is marked
with the letter L or colored red.
Line Fuse (16FX™ mixer only)
64
The fuse is located within the cap of the fuse holder. If the fuse fails, THE FUSE MUST BE REPLACED
WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT
VOIDING THE WARRANTY. If the mixer repeatedly blows the fuse, it should be taken to a qualified service
center for repair.
WARNING: The fuse should only be replaced when the power cord has been disconnected from its
power source!
19