Kermi x-net Instructions De Service page 4

EN – Manufacturer notes
Technical data
Maximum load:
Total own weight:
Dimensions when
1285/825/1185 mm
Dimensions when packaged
600/350/200 mm
Permitted use
The x-net unwinder is suitable for twist-free unwinding of
x-net system pipes from the packaging, for all pipe dimen-
sions from 10 to 20 mm external diameter.
Use for any other purpose is considered improper use and
is therefore not permitted! For safety reasons, modifica-
tions or changes to the x-net unwinder are not permitted!
Do not exceed the maximum load specified in the Tech-
nical Data!
INFORMATION
The operating instructions must be kept with the pro-
duct!
Safety information
These operating instructions included with the x-net
unwinder and the labels attached to the rotating turret
contain essential information that must be read before
putting into service!
Carry the x-net unwinder only with the handles pro-
vided on the feet! The folding support arms are not
suitable for carrying! Always ensure secure footing
when carrying!
Use only in areas where there is sufficient lighting!
CAUTION
During assembly and use, wear personal protective
equipment (gloves, safety shoes)!
Risk of crushing when folding out the support arms!
Note the weight of the unwinder with pipe bundle!
Carry the unwinder with pipe bundle only if enough
people are available.
Caution! Danger of slipping or tipping over if over-
tilted.
4
set up (length/width/height):
(length/width/height):
EN – Installation instructions
Before putting into service, check the unwinder for dama-
ge and completeness.
90 kg
Damaged parts must be replaced before putting into ser-
11 kg
vice. The carrying case provides secure transport only if
undamaged. Stability (horizontal support surface with suf-
ficient load capacity) must be checked and ensured before
using the x-net unwinder.
NOTE
When carrying out the following installation steps,
please pay attention to the drawings at the end of the-
se instructions.
A
Pipe bundle in cardboard packaging
B
Large pipe bundle in film packaging
C
Large pipe bundle in cardboard packa-
ging
1A
1B 1C
Carefully remove the x-net unwinder from the packa-
ging.
Insert the 3 feet sufficiently deeply into the holes in
the bottom of the body (the groove should no longer
be visible) and secure by turning through 180°.
CAUTION
Risk of injury!
If assembled incorrectly, the feet can fall out when
the x-net unwinder is lifted or carried!
First, fold the 3 support arms into vertical position
with a short movement, then fold them outwards by
90° into the horizontal position.
2A
Break out round perforations in the top and bottom of
the cardboard packaging.
Carefully place the cardboard packaging at the centre
of the unfolded support arms of the x-net unwinder
(before mounting the rotating turret).
Place the rotating turret with flange pointing vertically
downward (the 3 holes in the flange aligned with the
3 screw heads on the rotating turret mounting). Turn
the rotating turret until the locking bolt engages
automatically in the hole provided in the mounting.