Publicité
Les langues disponibles
Les langues disponibles
Front Panel
19
BASS, MIDDLE AND TREBLE EQ
11
Passive tone controls that regulate the low, mid and high frequencies of the Lead channel.
MASTER REVERB
12
Controls the overall reverb level.
EFFECTS SEND
13
1/4" output jack for supplying signals to external low-level effects or signal processing equipment.
EFFECTS RETURN
14
1/4" input for returning signals from external low-level effects or signal processing equipment. This is a
switching jack. Inserting a plug into this jack will break the signal path until it is returned via the
EFFECTS SEND (#13) jack.
RESONANCE (ValveKing
15
This patented feature, available only from Peavey, is used to fine-tune the low-frequency response and
damping factor of the power amp section. At higher settings, the speakers are allowed to move more
freely at low frequencies, resulting in more apparent low end with slightly less signal clarity at maximum
settings.
PRESENCE (ValveKing 212 and 100 Head only)
16
This control is used to fine-tune the high-frequency response and damping factor of the power amp sec-
tion. At higher settings, the speakers are allowed to move more freely at high frequencies, resulting in
more apparent high end.
PILOT LIGHT
17
Illuminates when AC power is being supplied to the amp.
STANDBY SWITCH
18
Placing this switch in the "Standby" position will effectively shut the amp off while leaving the tube
filaments on. Leave this switch in the "Standby" position for a minimum of one (1) minute after engaging
the POWER SWITCH (#19). This is also a useful feature, since much tube wear comes from the heating
and cooling of the tube itself. Leaving the unit in "Standby" when you take a break allows the tubes to
stay warm while you are not playing. To immediately resume normal amp operation with no warm-up
delay, place the switch in the "ON" position. NOTE: This switch does not replace the POWER SWITCH
(#19). When you are ready to stop playing for an extended period of time, it is better to turn the amp off
via the POWER SWITCH (#19).
POWER SWITCH
19
To apply power to the unit, flip the switch to the "ON" position. The red PILOT LIGHT (#17) will illumi-
nate, indicating power is being supplied.
18
17
16
15
14
13
11
®
212 and 100 Head only)
0
0
1
1
12
11
12
13
14
17
18
19
11
12
13
14
15
16
9
TM
0
1
17
18
19
Publicité
