Sharp PA-VR10E PC Mode D'emploi page 9

Press the OK button.
5
When "OK?" appears on the display, press the OK button
again.
The "RESET..." message appears on the
display briefly and changes to "RESET!",
then the screen for setting the date and
time appears.
To set the date and time, follow from step 5
of the procedure on page E-10.
• If the display does not appear, try pressing the reset button again.
If the display still does not appear, reinsert the batteries once again
by repeating steps 1 to 5.
Clock and standby mode screens
Clock mode screen
The recorder switches to the clock
mode if it is not used for approxi-
mately 30 seconds. To restore
recorder operation, press the OK or
PLAY/PAUSE button or any of the
cursor buttons (
standby mode screen shown below
then appears.
* If you press the RECORD/PAUSE button, the recorder starts
recording. There may be a gap of a few seconds before recording
actually begins. The indication "WAIT..." appears on the display
during this time.
L M
, , 1 , 0 ). The
RESET?
2005Y
Month Day
1 35 25 3
Time
display
E-7