Publicité
Les langues disponibles
Les langues disponibles
Mast installation and mast calculation (Fig. 1)
Make sure that the mast is in vertical position when mounting it
-
Only use masts or standpipes specially designed for antenna
-
installation. Other tubes mostly do not have the necessary
stability to withstand heavy wind or other climatical situations.
Kathrein-masts and clamps fulfil these requirements.
Find an overview of the masts provided by Kathrein on the last
page
The clampling range of the mast clamp of the OLYMPIA
-
antennas is from 22 mm to 60 mm
If the mast is to be mounted on a roof, you have to clamp at least
-
1/6 of its length
Mind that the mast holders (e.g. clamps) are mounted on solid
-
ground (wood, concrete, walls)
Installing several antennas on one mast
Never exeed the maximum load capacity of the mast or clamps
when mounting several antennas on one mast.
Antenna installation (Fig. 2)
1. If necessary, plug together the antenna parts, and fix them using
wing screws.
2. Fix the dipole with cable connection box on the antenna square
pipe using a knurled screw.
3. Open the reflector grille and fix it with the wing screws through
the antenna square pipe.
4. Open the mast clamp and fix the antenna on the mast.
Slightly screw the wing nuts on the mast clamp so that you
are able to align the antenna to optimum reception.
_____________________________________________________________
Fig. 1
Fig. 1
Fig. 2
Publicité
