hjh OFFICE COMPACT I Mode D'emploi page 7

Caution: When replacing batteries, do replace all the batteries at once and never use old fresh
batteries together. Never mix the specified batteries with other types of batteries in use.
Using personal code to close and open the safe
• Enter any 4 to 6-digit number then press the "#" key, the word „CLOSE" appears and the safe
will be closed.
• Enter your 4 to 6-digit number then the word „OPEN" appears and the safe will be opened
automatically, finally display shows „OPENED", which means safe has opened successfully.
Setting the personal code
In the state of door open, you can change any personal code (4 to 6-digits) when you close the
door.
Using master code open the safe
Enter your 6 digital master code, then the word „OPEN" appears and the safe will be opened auto-
matically, finally display showed „OPENED", which means open successfully.
Setting the master code
• Keep the door open, Press „*" twice, and „PROG" appears. After „PROG" disappears, input the
original master code (factory master code is 011223) and „EW" appears.
• After „NEW" disappears, input the new master code (6 Digits) you prefer within 5 seconds and
„AGAIN" appears.
• After „AGAIN" disappears, input the new master code again within 5 seconds and „DONE" ap-
pears, which means the master code has been changed successfully.
• If „ERROR" appears, it means the new master code setting failed.
The new code cannot be set as function code (such as: 751019 and 123456) to avoid confusion.
The original factory master code is 011223
Opening the safe in emergency
Once the electronic circuit malfunctioned or codes unknown. You can also use the override key to
open the safe.
EN
2