T.I.P. TSS INOX 1600 Mode D'emploi page 12

In addition to the basic safety precautions for avoiding accidents, please note the following:
1. CAUTION: Before performing any installation or maintenance work, disconnect the electrical
equipment from the power source by unplugging the power cord from the electrical outlet. The
appliance must not be operated if persons are in the water. Switch off the main fuse of the household
electricity supply before pulling out the mains cable if the connector or the mains socket is wet. Never
transport or hang up the unit on the mains supply line.
2. Make sure that the voltage indicated on the type plate of the appliance matches the mains voltage.
3. Before connecting the unit to the power supply, ensure that the power cord and the unit are not
damaged in any way.
4. A corresponding residual current circuit breaker (RCD) with a rated fault current of max. 30 mA.
Please contact a qualified electrician.

Packing parts can be dangerous (for example plastic bags) - therefore unachievable for children, for persons
who are unaware of their actions or for animals.

Only use accessories which are included in the scope of delivery or only those specified in the operating
instructions. Use of unauthorized accessories may affect safety.

Any use of the device, which is not described in this manual, can be dangerous and must therefore be
avoided.

Before draining the container manually, turn the unit off and unplug the appliance from the wall outlet.

When the appliance is operating, be careful not to hold the suction nozzle on a sensitive body (such as the
eyes, mouth or ears).

Children should be supervised so that they do not play with electrical appliances.

Before use, the unit must be assembled correctly with all parts. Check that the power outlet and the plug are
matched.

Never touch the mains plug with wet hands.

The max. System impedance of electrical supply systems for connecting devices with a 1600 watt motor is
Z = 0.12 + j0.08. If necessary, please inquire with your responsible utility for the existing system
max
impedances.

Switch off the appliance and unplug the mains plug before servicing, cleaning, changing the filter and after
use. Do not leave the appliance unattended; do not leave it in the reach of children or persons who are
unaware of their actions.

In the case of incidents (for example contact with detergents or chemicals), clean the machine with plenty of
clear water. In the event of a fault, always pull the mains plug to avoid danger.

Never leave the appliance unattended during operation.

Do not immerse the appliance in water or clean it with a water jet.

Make sure that the power cord, the housing or other parts of the appliance are damaged. If so, do not use the
device and make repair at the customer service.

If you use extension cables, make sure that they are suitable for the appropriate application and those they
are on a dry surface and are protected against splashing water.

Service and repairs may only be carried out by qualified personnel. Defective parts of the device may only be
replaced with original parts.

The manufacturer is not responsible for any damage to persons or objects caused by improper use of the
appliance or by ignoring the instructions given in this manual.
1.1. Special safety instructions for the pond cleaner

If the appliance falls over during operation, immediately switch off the appliance, unplug and then install the
appliance.

Always place your appliance in a suitable location. The device must not be placed on brackets, pedestals or
similar supports, but on a level and firm surface.

Never use the appliance to draw water from containers, sinks, etc. Do not absorb solid substances and under
any circumstances easily inflammable (eg ash or soot from the fireplace), explosive, toxic or harmful
substances.

Before swims, check the mobility of the float inside the sponge filter (R) inside the pond sludge filter.

Immediately turn the appliance off and unplug if liquid or foam escapes. Never use the unit without
the filter (R).

The appliance must not be used for pond emptying.

When installing the appliance, keep a safety distance of 2 m from the pond. The appliance must not be used
when people are in the water. Avoid working with the unit during rain.

Do not move the unit by pulling it on the hose.

The garden ponds must be laid out in accordance with international and national regulations and regulations.
10
2