inventiv 202091 Instructions D'origine page 22

202091 ROTARY HAMMER 800W
(6) (See B); release the on/off switch first and the lock-
on button second. Your switch is now locked on for
continuous use. To switch off your tool just depress
and release the on/off switch.
7. VARIABLE SPEED CONTROL (SEE D)
Adjust the variable speed control to increase or decrease
the speed according to the material and accessory to be
used (also possible during no load operation). Low speed
will provide low torque and high speed gives higher
torque.
8. FORWARD AND REVERSE ROTATION CONTROL
(SEE E)
For drilling use forward rotation marked "
is moved to the left). Only use reverse rotation marked
" " (lever is moved to the right) to release a jammed
drill bit.
WARNING: Never change the direction of rotation
while the tool is rotating, wait until it has stopped.
9. FUNCTION MODE SELECTION (See D)
The operation of the gearbox for each application is set
with the function mode selection switch (4). To change
between functions, depress the unlocking button (12)
and rotate the selector to the desired operating mode.
For impacting
only - for light
chipping,
chiseling and
demolition
applications
choose the
Hammer
position.
WARNING: The operating mode selector switch
may be actuated only at a standstill.
22
SAFETY AND OPERATING MANUAL
For drilling into
steel, wood and
plastics choose
the Rotary
masonry, choose
drilling position.
drilling position.
" (lever
For
simultaneous
drilling and
impacting of
concrete or
the Hammer