Publicité
Les langues disponibles
Les langues disponibles
202091 ROTARY HAMMER 800W
clockwise and rotate the handle around the hammer col-
lar until the handle is in the desired position. Tighten fully.
The Anti-vibration handle reduces the vibration, making
operation more comfortable and secure.
2. USING THE DEPTH GAUGE
The depth gauge can be used to set a constant depth
to the drill.
Rotate the locking sc rew on the top of the handle
anti-clockwise to loosen, insert the depth gauge into
the handle. Adjust it to the desired depth. Rotate the
locking screw clockwise to tighten.
3. FITTING BITS OR CHUCK (see B1)
Clean the bit shank and apply grease before installing
the bit. Hold the rotary grip, pull back the lock sleeve
and insert the bits or chuck into the bit holder. Turn
the bit and push it in until a resistance is felt. The shaft
drops completely into the bit holder. Once you are
satisfied that it has been seated, release the black lock
sleeve. This would lock the bits or chuck into position.
After installing, always make sure that the tool or chuck
is securely held in the bit holder by trying to pull it out.
If the bits or chuck is not located well, repeat the
operation again.
4. REMOVE BITS OR KEY CHUCK (see B2)
To remove the tool or chuck, pull back the locking sleeve,
hold and pull the tool or chuck out.
NOTE: The bits or chuck are gripped firmly by the shank
and can not be removed once locked in position.
5. OPERATING THE ON/OFF SWITCH (See C)
Depress the on/off switch for operation and release it to
stop.
Depress on/off switch then lock on button, release on/
off switch first and lock-on button second. Your switch
is now locked on for continuous use. To switch off your
tool just depress and release the on/off switch.
6. SWITCH LOCK-ON BUTTON
Depress the on/off switch (7) then the lock on button
21
SAFETY AND OPERATING MANUAL
Publicité
