SKYTRONIC 103.086 Manuel page 7

REMOTE
1. Power
2. Pic mode
3. Input Selector
4. Mute
5. OSD menu
6. Previous
7. Next
8. RWD
9. FF
10. OK
11. Up, down left, right button
12. Numbers
13. Turn
14. Exit
15. Volume plus
16. Volume minus
17. Play
18. Repeat
19. Info
Note: While playing video, press pic on the remote control to choose the setting that is better for your using.
FUNCTION OPERATION
Power On/Off
Standby Status : Connect the projector to power, the indicator will enter Standby Status after it
flashes.
Power on : Press the power button on the projector or remote controller, the indicator lamp will
be steady on after it flashes, the projector starts working.
Power off : Press the power button on the projector or the remote controller, the indicator lamp
will slowly flash, then it enters standby status.
Focusing
Put the projector with lens perpendicular to the screen or wall, rotate the focusing handle on the up
cover until the picture is clear to finish the focusing. In the process, you can play programs or turn to
OSD menu to coordinate the focusing adjustment.
MENU OPERATION
a. Input source selection
Press the input source select button on the projector or on the remote
controller, the input source select menu comes out, then press the
up/down button or the input source select button to select the channel
required, press OK button to confirm, the system will switch to the
required channel.
The projector has the channels as following:
TV：Television(option)
PC_RGB：PC
HDMI：HDMI
AV：Video and Audio
IP：Video and Audio
USB：USB