The First Flight - Kompernass QC 360 A1 Mode D'emploi

The first flight
♦ Switch on the remote control by moving the ON/OFF switch
position. The control lamp
♦ Move the throttle lever
♦ Connect the battery
plug connector
lamps
♦ Push the throttle lever
hear a short beep from the remote control. The quadrocopter's control lamps
light up permanently to signal that the quadrocopter is ready for flight.
NOTE
► The directional indications are always from the perspective of the "virtual"
pilot of the model aircraft. The two red control lamps
indicate the direction and mean "forwards".
QC 360 A1
flashes.
to the rear (motors off).
to the quadrocopter. To do this, connect the quadrocopter
to the battery plug connector
start flashing. The remote control beeps twice.
all the way forward and then all the way back. You will
Up/down
Forwards/backwards
to the "ON"
. The quadrocopter's control
on the quadrocopter
Turn left/right
Sideways left/right
GB │ IE │ 11 ■