Publicité
Les langues disponibles
Les langues disponibles
GETTING TO KNOW YOUR UNIT
Spring Retainer
SET UP INSTRUCTIONS
* Items shown in Set Up Instructions are not included with this tool.
u The air compressor used with your air hammer must be able to maintain a
minimum of 90 PSI when the tool is being used. An inadequate air supply can
cause a loss of power and inconsistent tool output/performance.
u A pressure regulator—used at the tool—is helpful to control the operating
pressure of the tool and maintain 90 PSI.
u Use an oiler to provide oil circulation through the tool and a filter to remove liquid
and solid impurities which can rust or "gum up" internal parts of the tool.
u To disconnect a coupler/plug from a system set-up: push the coupler and plug
together before pulling the coupler sleeve back and separating the coupler and
plug.
u Make sure that the chisels used with your pneumatic air hammer are heat-treated
steel for increased durability and longer life.
Threaded Barrel
Trigger
Air Hose
BEST PRACTICES
Exhaust Port
Quick
Coupler
Plug
3
Air Inlet
Spring Retainer
Whip Hose
Chisel
Publicité
