Publicité
Les langues disponibles
Les langues disponibles
u For best output, maintain pressure at the tool of 90 PSI.
u The longer your air hose the greater the pressure drop from compressor to tool.
If you are using a hose longer than 50 feet, consider upgrading to a 1/2 inch ID air
hose to ensure proper tool pressure.
u Failure to lubricate and maintain your air tools properly will dramatically shorten
their life. Use oil every time you use your air tool to lubricate, clean and inhibit rust
in one step. Campbell Hausfeld sells air tool oil under part number ST1270.
u Due to the excessive vibration created by this tool, a whip hose (aka leader hose) is
recommended. If using a whip hose, do NOT install a coupler set between the tool
and the whip hose.
SPECIFICATIONS
Maximum PSI
CFM under load 100% duty
SCFM under load 100% duty
Air Compressor Recommendation
Blows Per Minute (BPM)
Stroke Length
Chisel Shank Diameter
Air Inlet
Minimum Hose Size
Housing Material
Tool Weight
Tool Length
Tool Height
Tool Width
BEST PRACTICES
2
XT101000
90
3.1 CFM @ 90 PSI
23.9 SCFM @ 90 PSI
26 gallon
2,600
2-3/4 inch
0.401 Parker type
taper shaft
1/4 inch NPT (F)
3/8 inch
Composite
2.9 Lbs.
6-7/8 inch
6-3/8 inch
2-1/8 inch
Publicité
