Publicité
Les langues disponibles
Les langues disponibles
30
31
32
33
34
31.
MONITOR SIGNAL/PFL LED:
Normally indicates that a signal is present in the monitor of –20 dBu or greater. If the
Monitor PFL switch (32) is depressed, it lights continuously to indicate that the monitor
mix has been assigned to the PFL mix.
32.
MONITOR PFL Switch:
Connects the monitor's pre-fader signal to the PFL mix and switches the headphone source
from the L/R mix to the PFL mix.
33.
MONITOR 1 FADER:
Sets the overall level of the monitor signal that is sent to the Monitor 1 Output jacks (6). The
optimum setting for this control is the "0" (unity gain) position.
34.
MONITOR 2 FADER:
Sets the overall level of the monitor signal that is sent to the Monitor 2 Output jacks (7). The
optimum setting for this control is the "0" (unity gain) position.
35.
MASTER LEFT/RIGHT FADERS:
Master L/R level controls. Since the tape and headphone outputs come from this mix, they
will also be affected by its adjustment. The output levels are monitored by the left and right
meters. The optimum setting for this control is the "0" (unity gain) position.
36.
MONO OUTPUT FADER:
Sets the output of the Mono (L+R) signal found at the Mono Output (9).
35
36
28.
EFFECTS 2 SEND:
Adjusts the level of the Effects 2 mix sent to
the Effects 2 Output (5). Unity gain is at the
center detent position and +10 dB of gain in
maximum.
29.
LED METERS:
Two 12-segment LED arrays monitor the
levels of the main L/R outputs. The 0 dB
reference level corresponds to +0 dBu at the
1/4" jacks and XLR. (See 8.)
30.
MONITOR PEAK LED:
Indicates that the monitor mix level is nearing
the overload point. It illuminates at +19 dBu
and warns that gain or EQ boost should be
reduced. There is roughly 2 dB of headroom
remaining when it lights.
7
Publicité
