Publicité
Les langues disponibles
Les langues disponibles
8643405
ASSEMBLY AND ADJUSTMENTS
The air filter is designed to circulate air and filter wood and other non-metallic dust. The unit
requires only minimal assembly. However, it is important to consider how and where to place
the unit. When selecting a site, make sure there is a suitable power source nearby. Do not use
extension cords with the air filter.
HANGER PLACEMENT
1.
Thread the locknuts (1) almost all the way up the hanger (2).
2.
Thread a hanger into each of the four mounting holes (3) on the top of the air filter
cabinet.
3.
Tighten each locknut against the cabinet top. Hold the hangers so that they do not
spin while tightening the locknut.
CEILING PLACEMENT
Make sure the unit will be situated at least 7' above the floor and at least 3' (1 m) away from a
corner and from any heating or air vents.
1.
Install the wood screw hooks (4) into the building support structure. Do not mount
the air filter to non-structural surfaces such as drywall or false ceiling grids. The
hooks are rated for this air filter, and can support a minimum of 100 lbs.
2.
Place a chain (6) on each wood screw hook (4).
3.
Attach the hangers (2) on each chain (6).
4.
Make sure the unit is level horizontally, and is at least 7' above the floor. If it is not,
remove the air filter and adjust the length of the chain as needed. Then remount the
unit.
5.
Plug the air filter power cord directly into a power source.
Visit www.princessauto.com for more information
400 CFM Air Cleaner
(FIG. 1)
(FIG. 1 AND 2)
FIG. 1
V4.0
FIG. 2
7
Publicité
