ARIETE RoboMix metal Mode D'emploi page 13

- Insert the previously prepared foods through the opening in the lid (D), without exceeding the
maximum level indicated on the blender (C), then insert the cap (E) into the lid (D), pressing it
gently down into place.
- Switch on the appliance, selecting the blade rotation speed with the operating dial (A). The appli- -
ance has two speeds: minimum «1» and maximum «2».
It is also possible to select pulse operation by turning the dial (A) anticlockwise to «P». For the
best use of this function, only turn the dial for a very short time (2-3 sec.).
WARNING: Never operate the appliance for more than 30 seconds at a time. Wait at least 2 minutes
before operating it again.
WARNING: For softer fruit and vegetables (e.g., bananas), start at slow speed and then increase the
speed as required. For firmer fruit or vegetables (e.g., carrots), use the maximum speed.
- For a smoother result, switch off the appliance, unplug it from the mains power, remove the lid
(D) and use a spatula to move the foods away from the sides of the blender (C) and towards the
centre.
WARNING: To prevent accidents or damage to the appliance, always keep hands and cooking
utensils well away from moving blades or cutting discs.
WARNING: Never remove foods from the sides of the blender while the appliance is operating.
- Repeat the above steps for processing other foods.
WARNING: Never place more than 300g of firm fruit or vegetables into the blender at any one
time.
WARNING: To prevent liquid spills, never place more than 1000 ml of soups, purées or other liquids
into blender.
WARNING: Always fit the lid (D) before starting the blender.
WARNING: Before blending warm liquids, always remove the blender filler cap (E). Never place hot
liquids inside the blender.
CLEANING
WARNING: Always unplug the appliance from the mains power supply.
WARNING: Never place the power base, plug or power cord in water or other liquids.
WARNING: The blades are extremely sharp. Always handle them with care.
- Remove all of the attachments used, working in the opposite order to the way they were fitted.
- All attachments can be washed in the top rack of the dishwasher, at a maximum temperature of
50°C/ 122°F.
- Wipe the power base (B) clean with a slightly damp cloth.
- To clean the blender (C): fill the blender with lukewarm water and detergent and fit the lid (D) and
filler cap (E); operate the blender at maximum speed for 30 seconds. Rinse and repeat, if neces- -
sary.
WARNING: After cleaning, dry all parts thoroughly and refit them.
- The power cord can be wound around the relevant cord rewinder beneath the appliance (Fig.
13).
- 11 -
EN