ARIETE RoboMix metal Mode D'emploi page 11

DESCRIPTION OF THE APPLIANCE (Fig. 1)
A Operating dial
B Power base
C Blender
D Blender lid
E Blender lid filler cap
F Blade support
G Chopping blade
H Mixing blade
I Pusher
L Whisking disc
M Blade disc
N Julienne blade
O Slicing blade
P Chip cutting blade
Q Lid
R Central shaft
S Bowl
WARNING
The appliance is fitted with a device to stop it from operating if the lid (Q) is not correctly locked into
place and the bowl (S) or alternatively, the blender (C), is not correctly inserted.
INSTRUCTIONS FOR USE
WARNING: Make sure that the appliance is unplugged and that the control dial (A) is set to "0" before
cleaning it or fitting or removing attachments.
- Fit the central shaft (R) into the relevant into the relevant housing on the power base (Fig. 2).
- Place the bowl (S) on the power base (B), so that the arrow on the power base is lined up with the
arrow on the bowl, then turn the bowl anticlockwise (Fig. 3).
- Fit the blade support (F) on the central shaft (R) of the power base (Fig. 4).
Chopping, mixing or whisking
- To use the appliance as a chopper, fit the metal blade (G) onto the blade support (F), while for
mixing, fit the plastic blade (H) by making sure that the slots inside the base of the blade are in
line with the notches in the support and pressing the blade downwards (Fig. 5).
WARNING: The blades are sharp; handle them with care.
- To use the appliance to whisk egg whites or whip cream, fit the special attachment (L) onto the
blade support (F), as illustrated in Fig. 6.
WARNING: Before starting the appliance, make sure that the bowl (S) and the disc (L) are perfectly
clean and without any traces of butter or egg yolk.
- Cut the foods into small pieces (1.5 x 1.5 cm) and place them inside the bowl (S) or for mixing,
insert the ingredients.
WARNING: Never add foods over the maximum level marked on the bowl (S).
- 9 -
EN