Making Connections - Samson MediaOne BT Mode D'emploi

Making Connections

The MediaOne BT main input connections can be made via the rear panel RCA
inputs. Follow the simple steps and diagram below for a quick connection using a
standard recording console's control room outputs.
1. Connect the left and right speakers using the included two-conductor speaker
cable. To guarantee for the best performance and avoid phase cancellation
problems, connect the red speaker terminal of the right side speaker to the red
speaker terminal for the left side speaker, and the black speaker terminal of the
right side speaker to the black speaker terminal of the left side speaker.
2. Connect the audio output from your audio source such as a computer, MP3
player or portable audio device to the RCA inputs of the MediaOne BT right side
speaker.
3. Turn the MediaOne BT volume control completely counter-clockwise to the
minimum setting.
4. Connect the MediaOne BT to an AC power outlet using the included power
cable.
5. Turn the power switch on the MediaOne BT to the ON position.
6. Play music from you audio source and slowly raise the volume of the MediaOne
BT to a comfortable listening level.
Audio Output
to RCA Inputs
Note: Before plugging in and turning on, remember the "last on, first off" rule of
powered speakers. When powering up your system, be sure that all the wires are
connected, turn your mixer and any other outboard gear on, and then last turn on
your MediaOne BT. When powering down, turn your MediaOne BT off first and then
your mixer and outboard gear.
MediaOne BT
Speaker Wire
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MUST
NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION. SUITABLE FOR HOME OR OFFICE USE.
13